Replacing all rubber mounts at front of rear axle final drive suspension
Special tools required:
- 33 5 166
- 33 5 163
- 33 5 162
- 33 5 161
- 33 4 465
- 33 4 466
- 33 5 105
- 33 5 165
WARNING:
High-voltage system - danger to life
- Observe SAFETY INFORMATION for working with electric vehicles.
IMPORTANT:
Do not press in and out rubber mount several times.
Necessary preliminary tasks:
- Remove REAR AXLE FINAL DRIVE .
Withdrawing rubber mount:
Pull out rubber mount with special tools 33 5 166 , 33 5 163 , 33 5 162 , 33 5 161 , 33 4 465 and 33 4 466.
NOTE:
The milled recess of special tool 33 5 162
must point towards rear axle support.
Use ratchet ring spanner 33 5 105.
Use ratchet ring spanner 33 5 105.
Installing rubber mount:
IMPORTANT:
Align rubber mount horizontally by way of notches (1). Slot (2) on rubber mount points towards center of vehicle.
Pull on rubber mount (1) with special tools 33 5 165 , 33 5 163, 33 4 465 and 33 4 466 as far as it will go.
NOTE:
use ratchet ring spanner 33 5 105.