Replacement: Remounting intake pipe and camshaft sprocket
- Loosen screws (1).
- Remount the intake pipe (2).
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Intake pipe to oil pump | |
| M6x25 | 10 Nm |
- Hold down the camshaft sprocket (2) and the oil vacuum pump using a suitable tool and release the screw (1).
The screw (1) features a left-hand thread.
NOTE:
Carry out work with a second person assisting.
- Remount camshaft sprocket (1).
- Observe the installation position of the mounting flats (arrows) on the oil pump.
- Make sure that the labeling FRONT is visible on the camshaft sprocket (1).
- Replace the screw (1).
Parts: screw
- Hold down the camshaft sprocket (2) and the oil vacuum pump using a suitable tool and tighten the screw (1).
NOTE:
Carry out work with a second person assisting.
TIGHTENING TORQUE SPECIFICATIONS
| Sprocket wheel at the oil vacuum pump | ||
| M8 Important - left-hand thread Replace screw. |
1. Joining torque | 5 Nm |
| 2. Angle of rotation | 90° | |