Install heat management module

• Replace the profile seal (1)  and the O-ring (2). 

  Parts:  Profile seal and O-ring

• Make sure that the closure (3)  is correctly installed and remount the closure (3)  as needed.

Courtesy of BMW OF NORTH AMERICA, INC.

• Clean the sealing surfaces (1)  and (2). 

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the heat management module (1). 

Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the screws in order from (1)  to (6). 

Fig 1: Heat Management Module Screws Tightening Sequence

Courtesy of BMW OF NORTH AMERICA, INC.

• Lock and connect the coolant hoses (2)  and (3). 
• Connect connector (1). 

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING ACOUSTIC COVER AT FRONT .
• Refer to INSTALLING CHARGE AIR LINE .
• Refer to INSTALLING BOTH COOLANT EXPANSION TANKS .
• Refer to INSTALLING INTAKE SILENCER HOUSING .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE DESIGN COVER .
• Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .