Reset ultra-small quantity adaptation
NOTE:
TECHNICAL INFORMATION
If the DME control unit or an injector is replaced, minimum quantity adaptation must be reset. If an injector has been replaced on cylinder side, the minimum quantity adaptation must also be reset.
If the DME control unit or an injector is replaced, minimum quantity adaptation must be reset. If an injector has been replaced on cylinder side, the minimum quantity adaptation must also be reset.
- Connect the diagnostic system to reset the minimum quantity adaptation:
- Read out vehicle data
- Identification without vehicle test
- Start vehicle test
- Vehicle handling
- Service functions
- Drive
- Engine electronics
- Adjustment programs
- Delete adaptations
- Reset adaptation values
- Reset ultra-small quantity adaptation
Follow-up work
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to CONNECTING NEGATIVE BATTERY CABLE (ENGINE COMPARTMENT) .
- Refer to CONNECTING THE NEGATIVE BATTERY CABLE .
- Refer to ACTIVATING HIGH-VOLTAGE SYSTEM .
- Refer to INSTALLING THE FLAP IN THE RIGHT LUGGAGE COMPARTMENT TRIM PANEL .