12 31 020 Removing and installing/replacing alternator (N47 D16/20 K/U/O/T 1)
Necessary preliminary tasks:
- Read out the fault memory of the DDE control unit.
- Switch off ignition.
- Disconnect BATTERY NEGATIVE LEAD .
- Remove DRIVE BELT FOR ALTERNATOR .
- Remove THROTTLE BODY .
- Remove INTAKE PLENUM .
Release connector (1) and remove.
Slacken nut (2).
Tightening torque: 12 52 2AZ .
Disconnect positive battery cable from alternator.
Slacken nut (1).
Remove cover from deflecting element and undo bolt (1) beneath it.
Tightening torque: 12 31 2AZ .
Remove deflecting element.
Release screws (1).
Tightening torque: 12 31 1AZ .
Feed out alternator upwards and remove.
NOTE:
Check stored fault messages.
Clear diagnostic fault entries from fault memory.
Clear diagnostic fault entries from fault memory.