2300 Manual Transmission Assembly
2300 TRANSMISSION IN GENERAL - TIGHTENING TORQUE SPECIFICATION
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Transmission to engine (Aluminum screws/bolts are not magnetic). |
N55 | M12 | Replace aluminum screws. Joining torque and angle of rotation must be observed without fail. Joining torque Angle of rotation |
25 Nm 130° |
| N55/N47/B47/N20/S55/B58 | M8 | Steel screw | 19 Nm | |
| N55/N47/B47/S55/B58 | M12 | Steel screw | 66 Nm | |
| N55 | M10 | Steel screw | 38 Nm | |
| N20/S55 | M10 | Steel screw | 56 Nm | |
| Steel screws with Torx head | I-transmission | M8 | 19 Nm | |
| I-transmission | M10x40- 8.8 | 38 Nm | ||
| I-transmission | M10x50- 10.9 | 56 Nm | ||
| I-transmission | M12 | 66 Nm | ||
| 2AZ Oil drain plug/oil filler plug | K transmission (without S55) | Hexagon socket | 40 Nm | |
| K transmission (only S55) | Hexagon socket | 43±4 Nm | ||
| I-transmission | Hexagon socket | 43±4 Nm | ||
| I-transmission | M12x1.5 | 25 Nm | ||
| I-transmission | M18x1.5 | Steel screw without seal | 45 Nm | |
| 3AZ Cover plate to transmission | I-transmission | 7.6 Nm |
2300 TRANSMISSION IN GENERAL - TIGHTENING TORQUE SPECIFICATION
| Transmission designation | Type | Thread | Tightening specifications | Dimension |
|---|---|---|---|---|
| 2AZ Gearbox to clutch housing | B/C/D/E/F/G/H/I/7-speed SMG | M12 | 76 Nm | |
| 3AZ Reinforcement shell to transmission | B/C/D/E/F/G/H/I/7-speed SMG | M8 | 23 Nm | |
| 4AZ Oil drain plug/oil filler plug | B/C transmission | 50 Nm | ||
| D/E-transmission | 52 Nm | |||
| G/H-transmission | M18x1.5 hexagon socket | 35 Nm | ||
| H/I-transmission | M12x1.5 | 25 Nm | ||
| C/I-transmission | M18X1.5 | Steel screw without gasket | 45 Nm | |
| 7-speed SMG | 40 Nm | |||
| 5AZ Transmission extension | G/H-transmission | M10 | 46 Nm |
2300 TIGHTENING TORQUE OVERVIEW
| Holder for underbody protection | ||
| 3 Nm | ||