Install the high-pressure line between the high-pressure rail and the high-pressure Pump
- Thread in and install the high pressure line (3) .
- Tighten union nut (1) hand tight.
- Tighten union nut (1) .
TIGHTENING TORQUES SPECIFICATION
| High pressure line between the rail and the high pressure pump | ||
| M14x1.5 | tightening torque | 33 Nm |
- Tighten down screw (2).
TIGHTENING TORQUES SPECIFICATION
| Fuel line to cylinder head cover | ||
| 6x18 | tightening torque | 7 Nm |
Follow-up work
- Refer to INSTALLING THE IGNITION COILS .
- Refer to INSTALLING ACOUSTIC COVER AT REAR .
- Refer to INSTALLING THE TENSION STRUT ON THE STRUT TOWER .
- Refer to INSTALLING SOUND INSULATION AT THE CENTER OF THE FIREWALL UPPER PART .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Refer to CONNECTING THE NEGATIVE BATTERY CABLE .
- Refer to INSTALLING THE LUGGAGE COMPARTMENT FLOOR COVERING .