Removing the vibration damper
WARNING:
Hot surfaces
.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
Preliminary work
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION .
- Refer to REMOVING REAR UNDERBODY PROTECTION .
- Refer to REMOVING STARTER MOTOR .
- Refer to REMOVING THE INTAKE FILTER HOUSING .
- Refer to REMOVING CLEAN AIR PIPE .
- Refer to REMOVING FAN COWL .
- Refer to REMOVING THE DRIVE BELT FOR ALTERNATOR .
- Position special tool 0 496 595 (11 6 130) and fasten with screw (1).
- Slide counter support on screw (2) in direction of flywheel and turn the engine on the vibration damper until the gearing (3) can reach into the flywheel.
Tighten down screw (2).
- Release screws (1) and remove the vibration damper (2) from the top.