51 12 156 Removing and installing (replacing) rear bumper panel (2' Series coupe and convertible, 2017-2021)

Necessary preliminary tasks: 

• Refer to REMOVING BOTH REAR LIGHTS .

Release screws (1) on wheel arch cover (2) on left/right.

Courtesy of BMW OF NORTH AMERICA, INC.

Fold back wheel arch cover (1).

Release screw (2).

Tightening torque 51 12 4AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Only F87: 

Loosen screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Removing: 

1. Starting in area (2), carefully disengage individual guide tabs on left and right.
2. Repeat process for area (3).
3. Pull bumper panel (1) straight towards rear with aid of a second person.
4. Disconnect all plug connections.
5. Remove the bumper.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Latch mechanisms and guides (1) must not be damaged or missing.

If necessary, replace faulty sheet metal nuts left/right.

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement (depending on equipment): 

• Remount REAR REFLECTORS .
• Remount the cover for the towing eye
• Remount the number plate
• Punch HOLES FOR ULTRASONIC SENSORS .
• Install HOLDER FOR ULTRASONIC SENSORS .
• Change over the cover on the bumper trim panel

Courtesy of BMW OF NORTH AMERICA, INC.