35 31 000 Removing and installing or replacing clutch pedal (2' Series coupe and convertible, 2017-2021)

Necessary preliminary tasks: 

• Refer to REMOVING TRIM PANEL for foot levers.
• If necessary, Refer to REMOVING OVER-CENTER HELPER SPRING .
• If applicable, detach the air duct for footwell ventilation and push it up.

Push the locking bolts (2) out.

Installation note: 

Replace the locking bolts (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Detach retaining clip (1).

Unhinge the recoil spring (2).

Pull the clutch foot levers (3) off the bearing support.

Installation note: 

Replace retaining clip (1).

Locking clip (1) must be seated with both legs in the pin groove.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Check bearing bushings (1) and replace if necessary.

Lightly grease bearing bushings (1).

Courtesy of BMW OF NORTH AMERICA, INC.