Removing and installing/replacing side panel on dashboard on left or right (2' Series coupe and convertible, 2017-2021)
Special tools required:
- 00 9 327
When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).
Pull off seal (1) in the area of the side panel (2).
Unclip side panel from dashboard (2) in direction of arrow with special tool 00 9 327 and feed out at a slant to the rear.
If necessary, unlock plug connection on switch for front passenger airbag deactivation and unplug.
Installation note:
Latch mechanisms (1) and guide tab (2) on side panel (3) must not be damaged or missing.
Replacement (depending on version):