63 31 165 Removing and installing/replacing center console LED (2' Series coupe and convertible, 2017-2021)

Necessary preliminary tasks: 

• Refer to REMOVING RADIO AND IHKA CONTROLS .

Removal: 

When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).

Unclip trim (1) forwards from instrument panel trim (2).

Unlock and disconnect associated connector.

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out latch mechanism (1).

Pull out LED module (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Installation note: 

Clips and guides on trim (1) must not be missing or damaged.

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out latch mechanism (1).

Thread in LED module (2).

Installation note: 

Latch (1) must not be missing or damaged.

Make sure LED module (2) is seated correctly.

Courtesy of BMW OF NORTH AMERICA, INC.

Connect associated connector.

Clip trim (1) into instrument panel trim (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Required reworking: 

• Refer to INSTALLING RADIO AND IHKA CONTROLS .