3112 Wishbone And Strut With Rubber Mount
3112 AXLE GUIDE AND AXLE STRUT - TIGHTENING TORQUE SPECIFICATION
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Tension strut to front axle support | F15/F16/F85/F86 | M12 | Replace screw and nut. TIGHTENING IN NORMAL POSITION . Joining torque and angle of rotation must be observed without fail. Joining torque Angle of rotation |
100 Nm 90° |
| 2AZ Tension strut to swivel bearing | F15/F16/F85/F86 | M14 | Replace nut. | 80 Nm |
| 3AZ Lower wishbone to front axle carrier | F15/F16/F85/F86 | M14 | Replace nut. TIGHTENING DOWN IN NORMAL POSITION . |
165 Nm |
| 4AZ Lower wishbone to swivel bearing | F15/F16/F85/F86 | M14 | Replace nut. | 80 Nm |
| 5AZ Upper wishbone to body | F15/F16/F85/F86 | M10 | Replace screws and nuts. TIGHTENING DOWN IN NORMAL POSITION . Joining torque and angle of rotation must be observed without fail. Joining torque Angle of rotation |
38 Nm 90° |
| 6AZ Upper wishbone to swivel bearing | F15/F16/F85/F86 | M10 | Replace nut. | 56 Nm |
| 7AZ Lower wishbone to spring strut clevis | F15/F16/F85/F86 | M14 | Replace screw and nut. TIGHTENING DOWN IN NORMAL POSITION . Joining torque and angle of rotation must be observed without fail. Joining torque Angle of rotation |
140 Nm 90° |