31 53 040 Removing and installing/replacing right output shaft bearing support (X6 xDrive 50i)
Necessary preliminary tasks:
- REMOVE right output shaft.
Unfasten screws (2).
Tightening torque 31 60 1AZ .
Remove bearing block (3) from oil sump.
Installation note:
Replace O-RING .
Replace radial shaft seal at front. Refer to 31 51 020 REPLACING SHAFT SEAL FOR RIGHT OUTPUT SHAFT REP-REP-RAF1531-3151020 - V.5 (X6 XDRIVE 35I, X6 XDRIVE 50I) .