72 12 004 Removing and installing/replacing airbag module for driver's knee protection (X6 2015-2019)

WARNING: Read and comply with SAFETY REGULATIONS for handling airbag modules and pyrotechnical belt pretensioners.
Incorrect handling can activate airbag and cause injury.

Attention!

Operations on pyrotechnical devices may only be carried out by authorized experts.

Improper, unauthorized operations may result in serious dangers.

Unauthorized persons are strictly prohibited from performing any operations on this system.

Necessary preliminary tasks:

DISCONNECTING NEGATIVE BATTERY LEAD .
Remove trim panel for pedal mechanism

Removal:

Release screws (1).

Remove airbag module (2) and unlock the PLUG CONNECTION BEHIND IT AND DISCONNECT .

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Connect the connector to the airbag module (2).

Replace screws (1).

Parts: Bolts

Position the airbag module (2) and tighten screws (1).

Tightening torque 72 12 03AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Required reworking:

Install trim panel for pedal mechanism
CONNECTING BATTERY EARTH LEAD .