Replacing the gel pad for rain light solar mist sensor
Only valid for sensors with a 35 mm diameter.
Precondition
The gel pad for rain light solar mist sensor is removed
1 - Replacing the gel pad
NOTE:
RISK OF DAMAGE
Damage to the surface.
The use of sharp-edged tools can damage the surface.
Damage to the surface.
The use of sharp-edged tools can damage the surface.
- Only use microfiber cloths.
- Pull off the gel pad (1) manually.
Do not touch or damage the PCB (2).
- Remove present residual gel using a microfiber cloth.
- Clean the surface of the rain-light-solar-condensation sensor with a microfiber cloth soaked in a solvent cleaner R2.
| Consumable | ||
| Cleaning agent R2 | 500 ml | 83190417324 |
- Replace gel pad.
Parts: Gel pad
- Pull off the yellow protective film (1).
- Position the gel pad (1) centrally on the surface of the rain-light-solar-condensation sensor (2).
Do not squeeze out any air pockets present.
Air pockets disappear within 30 min after assembly of the sensor on the windshield.
- Pull off the protective film (1).