1141 OIL PUMPS WITH STRAINER AND DRIVE (X6 sDrive 35i, X6 xDrive 35i)

1141 OIL PUMP WITH STRAINER AND MOTOR - TIGHTENING TORQUE SPECIFICATION

	Type	Thread	Tightening specifications	Dimension
1AZ Intake pipe with oil deflector to crankcase lower section (bedplate)	N55	M6x30	Replace screws Thread repairs exclusively with Al Helicoil. Joining torque and angle of rotation must be observed without fail. Joining torque Angle of rotation	4 Nm 90°
2AZ Oil pump to bedplate	N55	M8x123	Replace screws Thread repairs exclusively with Al Helicoil. Joining torque and angle of rotation must be observed without fail. Joining torque Angle of rotation	10 Nm 180°
2AZ Oil pump to bedplate	N55	M8x31 M8x37	Replace screws Thread repairs exclusively with Al Helicoil. Joining torque and angle of rotation must be observed without fail. Joining torque Angle of rotation	10 Nm 90°
3AZ Chain module to crankcase and oil pump	N55	M6x16	Replace screws Thread repairs exclusively with Al Helicoil. Joining torque and angle of rotation must be observed without fail. Joining torque Angle of rotation	4 Nm 45°
4AZ Hydraulic valve of oil pump to crankcase	N55	M6x16	Joining torque Angle of rotation	4 Nm 45°
5AZ Sprocket to oil pump	N55	M8	Joining torque Angle of rotation	20 Nm 45°
6AZ Triangular drive to oil pump	N55	M6x16	Joining torque Angle of rotation	4 Nm 45°
7AZ Chain tensioner to crankcase	N55	M6x16		10 Nm