34 41 220 Removing and installing/replacing all parking brake shoes (X6 2015-2019)
Special tools required:
- 34 4 000
Installation note:
- REMOVE rear brake disk.
- Release electromechanical parking brake (EMF).
Adjust the PARKING BRAKE after having completed the repair.
NOTE:
During replacement of the hand brake coverings, the following components must also be replaced:
- Brake shoe expander
- Adjusting screw
- Spring set
Disconnect return springs (1) with brake spring pliers.
Installation note:
Return springs (1) must not be overelongated.
Check return springs (1) and replace if necessary.
Return springs (1) must not be mixed up.
Pay attention to installation position of adjusting screw (2).
Apply a thin coat of grease to bush and screw threads refer to BMW Service Operating Fluids.
NOTE:
Graphic without wheel hub.
Twist roll pins (1) 90° with special tool 34 4 000 and detach.
Remove brake pads (2).