34 11 220 Removing and installing/replacing both front brake discs (X6 2015-2019)

Special tools required: 

• 34 1 280 

Necessary preliminary taste: 

• Remove FRONT WHEELS .
• When removing and reinstalling brake discs, remove and clean brake pads. Refer to 34 11 000 REMOVING AND INSTALLING/REPLACING BRAKE PADS ON BOTH FRONT DISC BRAKES (1 PISTON CALIPER) REP-REP-RAF1534-3411000BASIS - V.6 (X6 2015-2019)  or 34 11 000 REMOVING AND INSTALLING/REPLACING FRONT BRAKE PADS ON BOTH DISC BRAKES (2 PISTONS) REP-REP-RAF1534-3411000 - V.7 (X6 2015-2019) .

Check minimum brake disc thickness:

• Position special tool 34 1 280 at three measuring points in area (1) and measure.
• Compare measuring result and lowest value with SETPOINT VALUE .

Courtesy of BMW OF NORTH AMERICA, INC.

Attention! 

New brake pads may only be fitted if the brake disk thickness is greater than the MINIMUM BRAKE DISC THICKNESS .

Release screws (1). Remove brake-caliper support.

Installation note: 

Tightening torque 34 11 2AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Attention! 

To release brake disc: Do not under any circumstances strike friction ring with a hammer or similar!

If necessary, carefully tap on base of brake disc chamber with a rubber mallet.

Clean contact surface of brake disc at wheel hub thoroughly and remove traces of corrosion.

Unevenness on contact surface may result in distortion of brake disc!

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) and remove brake disc (2).

Installation note: 

Replace screw.

Tightening torque 34 11 1AZ .