34 00 009 Perform brake test on test stand (X6 2015-2019)

Necessary preliminary tasks:

Check tires for damage
Check tire treads
Checking tire pressure
The brakes must be at normal operating temperature. To that end, warm up and dry off the brake discs by braking the vehicle a few times.

IMPORTANT:

Front brakes:

Courtesy of BMW OF NORTH AMERICA, INC.

Rear brakes:

Drive the rear wheels of the vehicle onto the brake tester
Place the selector lever in selector lever position "N"
Start the brake test stand
Press service brake pedal
Read off maximum brake power on left/right

Courtesy of BMW OF NORTH AMERICA, INC.

Parking brake:

IMPORTANT: The test may only be carried out with the engine switched off, the selector lever in the "N" position and the ignition switched on.

NOTE: The electromechanical parking brake can not be tested on a plate test stand!

Courtesy of BMW OF NORTH AMERICA, INC.

Drive the rear wheels of the vehicle onto the brake tester
Place the selector lever in selector lever position "N"
Turn off engine.
NOTE: When the engine is running, additional braking effect will otherwise be exerted by the DSC system on all the wheels.
Turn on ignition
Start the brake test stand
Activate parking brake, pull button (1) for this purpose
NOTE: Parking brake indicator light lights up red in display. Duo-servo brake (actuating unit) is applied. Brake tester switches off after wheels lock up (slip) or vehicle is pushed off the brake tester.
Read off maximum brake power on left/right

Courtesy of BMW OF NORTH AMERICA, INC.
Deactivate parking brake:
- Press button (1) and simultaneously press service brake pedal
  NOTE: Duo-servo brake (actuating unit) is released.