67 62 000 Removing and installing or replacing flat motor for front left or right power window regulator (X6 2015-2019)

Necessary preliminary tasks: 

• Remove SOUND INSULATION IN FRONT DOOR .
• Remove FRONT SECTION OF POWER WINDOW UNIT .

Release screws (1).

Tightening torque 51 33 1AZ .

Remove flat motor (2) from power window regulator.

Installation note: 

Retaining pins (3) must not be released!

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Make sure drive shaft (2) is correctly seated in mounting (1) at power windows (3).

Courtesy of BMW OF NORTH AMERICA, INC.

After installation: 

An initialization must be carried out in order to activate anti-trap mechanism.

OBSERVE  information on initializing power window regulator.