12 41 041 Replacing the engagement solenoid switch (X6 2015-2019)

Preliminary work needed:

Switch off ignition.
Remove STARTER MOTOR .

Slacken nut (1).

Remove cable head (2).

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Do not twist cable head (2) when tightening, risk of short circuit to starter motor housing.
Tightening torque 12 41 1AZ (for N55) or 12 41 1AZ (for N63).

Unscrew the screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Remove the solenoid switch (1) and the spring (2).

Detach the bolt (3).

Installation note:

Check the bolt (3) for wear and grease the bolt.

Courtesy of BMW OF NORTH AMERICA, INC.