31 12 Front Wishbone And Strut With Rubber Mount (X6 M)
31 12 AXLE GUIDE AND AXLE STRUT - TIGHTENING TORQUE SPECIFICATIONS
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Tension strut to front axle support Replace screw and nut. Tighten in NORMAL POSITION . Joining torque and angle of rotation must be observed without fail. |
F15/F16/F85/F86 | M12 | Joining torque | 100 Nm |
| Angle of rotation | 90° | |||
| 2AZ Tension strut to swivel bearing | F15/F16/F85/F86 | M14 | Replace nut. | 80 Nm |
| 3AZ Lower wishbone to front axle carrier | F15/F16/F85/F86 | M14 | Replace nut. Tighten down in NORMAL POSITION . |
165 Nm |
| 4AZ Lower wishbone to swivel bearing | F15/F16/F85/F86 | M14 | Replace nut. | 80 Nm |
| 5AZ Upper wishbone to body Replace screws and nuts. Tighten down in NORMAL POSITION . Joining torque and angle of rotation must be observed without fail. |
F15/F16/F85/F86 | M10 | Joining torque | 38 Nm |
| Angle of rotation | 90° | |||
| 6AZ Upper wishbone to swivel bearing | F15/F16/F85/F86 | M10 | Replace nut. | 56 Nm |
| 7AZ Lower wishbone to spring strut clevis Replace screw and nut. Tighten down in NORMAL POSITION . Joining torque and angle of rotation must be observed without fail. |
F15/F16/F85/F86 | M14 | Joining torque | 140 Nm |
| Angle of rotation | 90° |