Drain and top up engine oil (S63T2) (X6 M)
Special tools required:
- 11 9 240
When carrying out repair work on the vehicle always wear oil- and heat-resistant protective gloves incl. forearm protection, face guard and protective apron.
engine damage .
Recycling:
Catch and dispose of drained engine oil in a suitable collecting vessel.
Observe country-specific waste disposal regulations.
Removal:
Open sealing cap (1).
Remove oil drain plug (1).
Drain engine oil.
Loosen oil filter lid with special tool 11 9 240.
Release oil filter element (1) in direction of arrow from oil filter cover (2).
Installation:
Replace O-ring and coat with engine oil.
Parts: O-ring.
Check identification (1) and mount the oil filter element in correct position.
Slide oil filter element (2) into oil filter cover (3).
Tighten oil filter lid with special tool 11 9 240.
Tightening torque: 11 42 1AZ .
Replace sealing ring (2).
Parts: Sealing ring (2).
Position oil drain plug (1) of oil sump on the oil sump and tighten.
Tightening torque: 11 13 1AZ .
Pour in ENGINE OIL .
Close sealing cap (1).
Checking oil level:
- Park vehicle on a horizontal surface
- Allow engine to run at operating temperature for three minutes with increased engine speed (approx. 1100 rpm)
- Read off oil level in instrument cluster or on control display
- Top up engine oil if necessary