Removing and installing/replacing pull cable for hood/bonnet locks at front (X6 M)

Necessary preliminary tasks: 

• Remove the engine COMPARTMENT LID CATCH ON THE RIGHT  and LEFT ENGINE COMPARTMENT LID LOCK .

Unclip clutch housing Bowden cable (1) at marked points.

Installation note: 

Clips must not be damaged.

To open up clutch housing cover, lever up cover (2) in direction of arrow.

Courtesy of BMW OF NORTH AMERICA, INC.

Feed rear Bowden cable (2) out of holder (1) and clutch housing (3).

Courtesy of BMW OF NORTH AMERICA, INC.