11 13 Oil sump
TIGHTENING TORQUE SPECIFICATION - OIL SUMP
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Oil drain plug to oil sump | N55 | M12x1.5 | Replace sealing ring. | 25 Nm |
| 2AZ Oil sump (aluminium) to crankcase lower half. | N55 | M8x26 | Replace screw. Thread repairs exclusively with aluminium Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. Jointing torque Angle of rotation |
8 Nm 90 ° |
| 3AZ Oil sump (aluminium) to crankcase lower half. | N55 | M8x92 M8x112 | Replace screw. Thread repairs exclusively with aluminium Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. Jointing torque Angle of rotation |
8 Nm 180 ° |
| 4AZ Oil sump (aluminium) to crankcase lower half (AWD) | N55 | M8x36 | Replace screw. Thread repairs exclusively with aluminium Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. Jointing torque Angle of rotation |
8 Nm 90 ° |
| 5AZ Oil deflector to crankcase lower half. | N55 | M6x20 | Replace screw. Thread repairs exclusively with aluminium Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. Jointing torque Angle of rotation |
4 Nm 90 ° |
| 6AZ Transmission to oil sump. | N55 | M8x50 8.8 | 19 Nm | |
| 7AZ Oil level sensor to oil sump. | N55 | M6 | 8 Nm |