11 78 510 Replacing the control sensor (PHEV)

Special tools required:

WARNING: High-voltage system - danger to life

WARNING: Risk of burning!
Work should only be carried out on an exhaust system that has cooled down.

Release control sensor (1) with special tool 11 7 030.

Fig 1: Identifying Control Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Installation note:

The threads of new control sensors are already coated with NEVER-SEEZ COMPOUND 4.3 .

If an control sensor is used again, only the screw thread may have a thin and uniform coating of NEVER-SEEZ compound applied to it.

Sensor ceramics not cleaned and not coated with lubricant.

Tighten control sensor (1) with special tool 11 7 030.

Tightening torque 11 78 1AZ .

Fig 2: Identifying Control Sensor

Courtesy of BMW OF NORTH AMERICA, INC.