66 53 010 Calibrating reversing camera
NOTE:
Calibration of reversing camera must be carried out after the following work:
- Removal and installation/replacement of reversing camera
- Repair work on the rear area of the body
- Adjusting work at tailgate
Attention!
Follow instructions and specifications in procedure.
To obtain an optimum result, always adhere to the following conditions:
- Vehicle standing level on headlight aiming station
- Rear seat bench is unoccupied
- Do not swap seats during calibration
- Steering wheel in straight-ahead position
- Do not move steering wheel
NOTE:
Also switch on reversing camera by means of PDC button.
Calibration can only be carried out with the diagnosis system.
Equipment specification with rear view camera:
Carry out the service function:
- Driver assistance
- Rear view camera
- Calibration of the reversing camera
Equipment specification with all-round vision camera:
Carry out the service function:
- Driver assistance
- All-round vision camera
- Calibration and teaching in for all-round vision camera
Using a special tool is no longer required for vehicles with a production date from 03/2011!