11 61 068 Removing and installing/replacing right intake plenum (N63)

Necessary preliminary tasks:

Disconnect plug connection (1) at servomotor for eccentric shaft (2).

Fig 1: Identifying Servomotor Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip wiring harness from clamps (1).

Disconnect plug connection (2).

Release screws (3).

Tightening torque: 13 62 2AZ .

Remove pressure sensor (4).

Installation note:

Replace O-ring.

Illustration of Cylinders 5 - 8.

Fig 2: Identifying Pressure Sensor, Wiring Harness Clamps, Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Remove heat shield (2).

Installation note:

Pay attention to installation position.

Fig 3: Locating Heat Shield Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts (1).

Tightening torque: 11 61 1AZ .

Remove intake plenum (2).

Fig 4: Identifying Intake Plenum And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Replace all sealing rings (1).

Observe mounting pin on the differentiated air intake system.

Fig 5: Identifying Sealing Ring And Mounting Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine and vehicle.

Check air intake system for leaks with diagnosis system.