63 11 560 Removing and installing/replacing the headlight driver module

WARNING: Version with xenon lighting system: Danger to life due to high voltage! Disconnect all components from voltage supply before removal.
Work on the entire xenon lighting system (ignition device, control unit and bulb) may only be carried out by qualified personnel.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Unlock and disconnect the connector (1).

Unfasten screws (2).

Tightening torque 63 11 2AZ .

Pull headlight driver module (3) out of headlight in direction of arrow.

Fig 1: Pulling Headlight Driver Module Out Of Headlight

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Gasket (1) must not be damaged and must be installed free from grease.

Guides must not be damaged or missing.

Fig 2: Identifying Gasket

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Teach in headlight driver module (1) via vehicle diagnosis.

Service functions
Body
Lights
Initialize the headlight driver module and teach in LEDs in headlight
If necessary, perform encoding