12 36 Control units (electric machines)
TIGHTENING TORQUE SPECIFICATION - CONTROL UNITS (ELECTRIC MACHINES)
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ High-voltage cable to EME and automatic transmission | F15PHEV | M6 | Tighten screws in crosswise sequence. Jointing torque Tightening torque |
3 Nm 8 Nm |
| 2AZ High-voltage cable holder to transmission carrier | F15PHEV | M6 | 8 Nm | |
| 3AZ Potential compensation line on body | F15PHEV | M8 | 19 Nm | |
| 4AZ Equiopotential bonding line to EME | F15PHEV | M8 | 19 Nm | |
| 5AZ Ground cable to body | F15PHEV | M8 | 19 Nm | |
| 6AZ Earthing cable to | F15PHEV | M8 | 15 Nm | |
| 7AZ Positive battery cable on EME | F15PHEV | M8 | 15 Nm | |
| 8AZ EME holder to body | F15PHEV | M6 | 19 Nm | |
| 9AZ EME holder to EME | F15PHEV | M8 | 19 Nm | |
| 10AZ Convenience charging electronics holder to body | F15PHEV | M8 | 19 Nm | |
| 11AZ Convenience charging electronics holder to convenience charging electronics | F15PHEV | M6 | 8 Nm | |
| 12AZ Potential compensation line to tunnel | F15PHEV | M6 | 8 Nm | |
| 13AZ Potential compensation line to convenience charging electronics | F15PHEV | M6 | 8 Nm | |
| 14AZ Tension relief on EME | F15PHEV | M6 | 12 Nm | |
| 15AZ High-voltage cable holder to EME | F15PHEVIM6 | 12 Nm | ||
| 16AZ High-voltage cable on holder for high-voltage cable | F15PHEV M6 | 8 Nm | ||
| 17AZ Cover for tension relief | F15PHEV M6 | 8 Nm | ||
| 18AZ Heat protection on under surface | F15PHEV | Plastic nut | Sheet metal nut Sheet metal screw Oval-head screw |
2.5 Nm 2.5 Nm 2.5 Nm 4.5 Nm |