51 11 050 Removing and installing/replacing support for front bumper panel

Necessary preliminary tasks:

IMPORTANT:

Release expanding rivet (1).

Fig 1: Identifying Expanding Rivet

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connection (1) on left and right and disconnect.

Remove impact absorber (2).

Installation note:

The impact absorber (2) must not be reused.

First attach impact absorber (2) at the bottom and then press on at the top.

Fig 2: Identifying Impact Absorber And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew bolts (1) and (2) from the back.

NOTE: Depending on engine variant, only bolts (1) may be fitted.

Fig 3: Identifying Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew bolt (1) on support.

Tightening torque 51 11 12AZ .

Unfasten screws (2).

Tightening torque 51 11 4AZ .

Diesel vehicles only:

Undo screws (3) and nuts (4).

Replacement:

Unscrew bolt (5) and swap over bracket.

NOTE: Carry out work on the left side in the same way as for the right side illustrated here.

Fig 4: Identifying Bolt On Support

Courtesy of BMW OF NORTH AMERICA, INC.

Remove support.