11 11 Engine Block (X5 M)
11 11 ENGINE BLOCK - TIGHTENING TORQUE SPECIFICATIONS
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Bearing cap to crankcase (ASA collar bolt) | S63T2 | M11x99 | Replace bolts, screw in hand-tight | |
| Joining torque | 20 Nm | |||
| Angle of rotation | 115° | |||
| 2AZ Bearing cap to crankcase (ASA collar bolt 10.9) | S63T2 | M8x70 | Replace screws. | |
| Joining torque | 10 Nm | |||
| Angle of rotation | 55° | |||
| 3AZ Threaded support sleeves | S63T2 | Joining torque | 6 Nm | |
| 4AZ Angled screw connection to crankcase | S63T2 | M8x37 | Flange head screw 10.9 | |
| Joining torque | 10 Nm | |||
| Angle of rotation | 45° | |||
| 5AZ Screw plug, gutter strip | S63T2 | M14x1.5 | Replace gasket. | 25 Nm |
| 6AZ Screw plug, main oil gallery rear and in V-space right | S63T2 | M18x1.5 | Replace gasket. | 25 Nm |
| 7AZ Oil nozzle to crankcase | S63T2 | M12x1 | 10 Nm | |
| 8AZ Special tool to crankcase | S63T2 | M8x35 | 20 Nm | |
| 9AZ Special tool to crankcase | S63T2 | M10x35 | 40 Nm | |
| 10AZ Special tool 11 8 930 to special tool 00 2 300 | S63T2 | M14x35 | 160 Nm |