Removing and installing or replacing trim panel for cover on left or right side member (X5 M)
Release rivet (1) on wheel arch trim (2).
Release wheel arch trim (2) in the rear section.
Installation note:
Replace rivet (1).
Release rivet (1) on rear wheel arch trim.
Detach cover (2) at clip (3).
Release screws (4).
Installation note:
Replace rivet (1).
If necessary, replace faulty clip (3).
Release clips (1) and screw (2).
Installation note:
If necessary, replace faulty clips (1).
Fit clips (1) with O-rings.
Unclip trim panel (1) in area (A).
Open doors.
Release trim panel (1) at clip (2) and latch mechanisms (3) and remove in direction of arrow.
Installation note:
If necessary, replace faulty clip (2).
Installation note:
Latch mechanisms (1) on holder (2) must not be damaged.