Removing and installing/replacing left or right actuator (active pedestrian protection) (X5 M)
WARNING:
Adhere to the following SAFETY INFORMATION so as to avoid a danger of injury by the actuator.
The BATTERY NEGATIVE LEAD must be clamped off prior to work on the actuator or engine compartment lid!
Do not exert any force on the actuator.
Incorrect handling may result in triggering of the actuator and thereby cause serious injury.
The BATTERY NEGATIVE LEAD must be clamped off prior to work on the actuator or engine compartment lid!
Do not exert any force on the actuator.
Incorrect handling may result in triggering of the actuator and thereby cause serious injury.
Necessary preliminary tasks:
Disconnect BATTERY EARTH LEAD .
Removal:
Unfasten plug connection (1) and disconnect.
Release bolt (2) and remove actuator (3).
Installation:
Comply with NOTES regarding handling active pedestrian protection.
Install actuator (3) and tighten bolt (2).
Tightening torque 41 61 3AZ .
Attach plug connection (1).
Required reworking:
Connect BATTERY EARTH LEAD .