Removing and installing/replacing flat motor for rear left or right power window regulator (X5 M)
Necessary preliminary taste:
- Remove REAR POWER WINDOW REGULATOR .
Release screw connections (1).
Tightening torque 51 35 1AZ .
Remove flat motor (2) from power window regulator.
Installation note:
Retaining pins (3) must not be released!
Installation note:
Make sure drive shaft (2) is correctly seated in mounting (1) at power windows (3).
IMPORTANT:
Ensure that the flat motor (2) is assembled without tension.
After installation:
An initialization must be carried out in order to activate anti-trap mechanism.
Read and comply with NOTES on initialization of power window regulator.