51 23... Adjusting/replacing bump stops
The illustrations are schematic representations and are to be applied to the relevant vehicle type.
Version 1:
Following parts must not be damaged:
- (1) Bump stop
Adjust bump stop (1) to correct height by turning left or right.
Version 2:
Replace damaged bump stops:
- (1) Bump stop with ejector
Press ejector (1) into bump stop and, in this position, twist approx. 90° counterclockwise with a Phillips screwdriver.
This locks the ejectors (1) in the bump stops.
Adjust bump stop (2) to correct height by turning left or right.
Unlock the ejector (1) again after completing adjustment.
Version 3:
Replace damaged bump stops:
- (1) Bump stop
Turn lock (1) 45° counterclockwise.
Pull bump stop (2) upwards.
Close lid slowly until it is at the same height as the side panel.
Open lid and turn lock (1) clockwise.
Installation:
Press bump stop into panel and drive in expanding pins (3).
The illustrations are schematic representations and are to be applied to the relevant vehicle type.
Prerequisite: Lid must be correctly adjusted.
Following parts must not be damaged:
- (1) Bump stop
- (2) Catches
Remove stop pad by pressing latch mechanisms back.
Screw in stop pad (1) to create distance to front compartment lid.
Place a cone (2) of modeling or sealing compound on the stop pad.
Slowly close bonnet.
Raise bonnet.
Compressed cone (1) determines distance between stop pad and front compartment lid.
Measure dimension a between compressed cone and edge (1) of stop pad.
Adjust measured dimension a + 0.5 mm by unscrewing stop pad (1).