51 11... Removing and installing/replacing front bumper trim cover (X line)

Release screws (1).

Tightening torque 51 75 1AZ .

Fig 1: Identifying Front Bumper Trim Cover And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release latch mechanisms (1) and remove cover (2) towards front.

Fig 2: Removing Front Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Latch mechanisms (1) on cover (2) must not be damaged or missing.

Fig 3: Identifying Latch Mechanisms On Cover

Courtesy of BMW OF NORTH AMERICA, INC.