66 20 537 Removing and installing/replacing a rear middle right ultrasonic transducer (Park Distance Control)

WARNING: Risk of burning!
Work on the exhaust system may only be carried out when it has cooled down!

Lift out plastic rivets.

Installation note:

Replace plastic rivets.

Undo nuts in marked area (1).

Remove cover (2).

Fig 1: Locating Plastic Cover Rivets And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: For purposes of clarity, illustration shows bumper removed.

Unlock latch mechanisms (1).

Remove ultrasonic sensor (2).

Fig 2: Identifying Ultrasonic Sensor And Latch Mechanisms

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connection (1) and disconnect.

Remove ultrasonic sensor (2).

Installation note:

Before installation of ultrasonic sensor (2) on wiring harness, clean plug connection!

Fig 3: Identifying Ultrasonic Sensor And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure rubber ring (1) is correctly seated on ultrasonic sensor (2).

Fig 4: Identifying Rubber Ring And Ultrasonic Sensor

Courtesy of BMW OF NORTH AMERICA, INC.