33 41 151 Replacing left or right wheel bearing on rear axle shaft

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Do not damage multipole impulse ring.

Fig 1: Identifying Multipole Impulse Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Necessary preliminary tasks:

Remove DRIVE FLANGE FOR REAR AXLE SHAFT

Release screws.

Remove wheel bearing.

Installation:

Stick in screws again/replace.

Tightening torque 33 41 2AZ .

Fig 2: Locating Wheel Bearing Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Keep contact surface (2) of wheel bearing/wheel carrier clean and free from oil and grease.

Except when replacing: Recondition tapped holes (1).

Install new wheel bearing.

Fig 3: Identifying Tapped Holes And Contact Surface

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Adjusting PARKING BRAKE