65 50 011 Removing and installing (replacing) video module for onboard monitor

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

NOTE: Follow instructions for HANDLING OPTICAL FIBRES .

Necessary preliminary tasks:

Disconnect BATTERY NEGATIVE LEAD
Remove luggage compartment trim panel on left. See LEFT LUGGAGE COMPARTMENT WHEEL ARCH TRIMor LEFT LUGGAGE COMPARTMENT WHEEL ARCH TRIM (WITH 3RD SEAT ROW) .

Release screws (1).

Feed out video module (2) complete with holder towards top.

Fig 1: Identifying Video Module And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The number of plug connections (1) and screws (2) can vary, depending on the video module version.

Disconnect plug connection (1).

Release screws (2) and remove holder from video module for on-board monitor.

Fig 2: Identifying Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out VEHICLE PROGRAMMING AND CODING .

After replacing the video module and programming, it is absolutely essential to reset the TV standard of the country in question.