65 12 200 Removing and installing (replacing) audio system controller
WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
.
Comply with notes and instructions on HANDLING OPTICAL FIBRES .
Comply with notes and instructions on HANDLING OPTICAL FIBRES .
Necessary preliminary tasks:
- Clamp off BATTERY NEGATIVE LEAD
- Remove MIDDLE TRIM FOR INSTRUMENT PANEL
NOTE:
Work is shown on the E60 by way of example. There may be differences in detail in the case of other car models.
IMPORTANT:
Do not scratch center console trim, cover if necessary.
Release screws (1).
Tightening torque 65 11 6AZ .
Pull back audio system controller (2) slightly.
Disconnect associated plug connections.
Remove audio system controller (2).
Replacement:
Carry out VEHICLE PROGRAMMING/ENCODING .