65 83 590 Removing and installing/replacing gyro sensor drive for Car Communication Computer

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary tasks:

Remove CAR COMMUNICATION COMPUTER

If necessary, cut through warranty seal.

Release bolts (1).

Remove floor pan (2) towards bottom and set down.

IMPORTANT: Contact spring strip (3) on floor pan (2) must not be bent: otherwise risk of short-circuiting!
When reinstalling floor pan (2), make sure individual springs of contact spring strip (3) are correctly seated.

Fig 1: Identifying Contact Spring Strip On Floor Pan

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolt (1).

Detach gyro sensor for Car Communication Computer (2) in direction of arrow from plug-in contact (3).

Fig 2: Detaching Gyro Sensor For Car Communication Computer

Courtesy of BMW OF NORTH AMERICA, INC.