65 83 570 Removing and installing/replacing CD drive for Car Communication Computer

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

12 7 192

Attention!

Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Risk of damage!

Place Car Communication Computer on special tool 12 7 192 (antistatic mat) and connect to earth/ground.

Necessary preliminary tasks:

Remove FRONT TRIM HOLDER FOR CAR COMMUNICATION COMPUTER

Release screws (1), remove CD drive and place to one side.

Installation note:

Ensure correct cable routing.

Fig 1: Identifying CD Drive And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release screws (1) and remove lid (2) from CD drive.

Fig 2: Identifying CD Drive Lid And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Cut through warranty seal (1) at marked point.

Release screw (2).

Lift side cover out of mounting (3) and carefully place to one side.

Fig 3: Identifying Warranty Seal, Screw And Mounting

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) and remove CD drive.

Installation note:

Ensure correct cable routing.

Fig 4: Identifying CD Drive Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Special tools required:

64 1 020

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) !

Necessary preliminary tasks:

Remove FRONT TRIM FOR CAR COMMUNICATION COMPUTER

If necessary, cut through warranty seal.

Raise cover (1) around edges and remove from Car Communication Computer (2) using special tool 64 1 020 .

Fig 1: Removing Cover From Car Communication Computer Using Special Tool (64 1 020)

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolts (1).

Feed CD drive for Car Communication Computer (2) in direction of arrow out of Car Communication Computer (3) and set down.

Installation:

Ensure correct routing of cables.

Fig 2: Removing CD Drive For Car Communication Computer

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolts (1).

Remove CD drive trim (2) in direction of arrow from CD drive for Car Communication Computer (3).

Installation:

Ensure correct routing of cables.

Fig 3: Removing CD Drive Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Cut through warranty seal (1) at marked point.

Release screw (2).

Lift side cover out of mounting (3) and carefully place to one side.

Fig 4: Identifying Warranty Seal, Screw And Mounting

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) and remove CD drive.

Installation:

Ensure correct routing of cables.

Fig 5: Identifying CD Drive Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.