65 75 055 Removing and installing/replacing emergency power siren with tilt sensor

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT LEFT WHEEL ARCH COVER

NOTE: On RHD vehicles remove FRONT RIGHT WHEEL ARCH COVER

Release screws (1) and remove cover (2).

Installation note:

Make sure rubber grommet (3) is correctly seated.

Fig 1: Identifying Cover, Rubber Grommet And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove housing (2) and disconnect associated plug connection.

Fig 2: Identifying Housing Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release nut (1) and remove emergency power siren with tilt alarm sensor (2).

Fig 3: Identifying Emergency Power Siren / Tilt Alarm Sensor And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!
Guides (1) of emergency power siren (2) must be correctly seated in area (3) of holder (4)!

Fig 4: Identifying Emergency Power Siren, Guides And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out VEHICLE PROGRAMMING/ENCODING .