65 77 720 Removing and installing (replacing) left B-pillar sensor

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: NOTE AIRBAG SAFETY INSTRUCTIONS !
Incorrect handling can activate airbag and cause injury.

Necessary preliminary tasks:

DISCONNECT BATTERY NEGATIVE LEAD and cover
Remove FRONT ENTRANCE COVER STRIP
Remove seat belt retractor with holder

Version with rear cabin air conditioning:

Remove FRONT SEAT
Remove rear cabin ventilation duct from B-pillar
Partially detach carpet in area of B-pillar
If necessary, remove rear cabin ventilation duct under carpet

Release screws (1), feed out sensor and disconnect associated plug connection.

Tightening torque 65 77 3AZ .

Fig 1: Identifying B-Pillar Sensor Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Establish correct positioning of B-pillar sensor (1) by means of guide pin (2) and screw (3).

Fig 2: Identifying B-Pillar Sensor, Guide Pin And Screw

Courtesy of BMW OF NORTH AMERICA, INC.