66 51 030 Removing and installing/replacing camera for Lane Departure Warning

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Expand two-part mirror base cover (1) by pressing from below and detach.

Feed out two-part mirror base cover (1) and remove.

NOTE: Latch mechanisms of two-part mirror base cover (1) must not be damaged.

Fig 1: Removing Mirror Base Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Slide camera (1) in direction of arrow out of mounting.

Disconnect plug connection (2).

Installation note:

Make sure camera (1) is firmly seated in mounting.

Replacement:

Carry out calibration via BMW diagnosis system:

Service functions:

Body
Lane departure warning
Calibrate camera

Fig 2: Identifying Camera And Plug Connection
Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Heating of camera for lane departure warning is integrated in windscreen.
If heating is defective, the windscreen must be replaced!