41 61 000 Removing And Installing Hood/Bonnet
WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Danger of injury!
Support engine hood in fully opened position with suitable apparatus.
Support engine hood in fully opened position with suitable apparatus.
IMPORTANT:
Removal of the hood/bonnet must be carried out with the assistance of a second person.
NOTE:
Carry over schematic representation to the relevant vehicle type.
Release nuts (1).
Tightening torque 41 61 1AZ .
Remove hood lid.
Installation:
Install engine hood at screw locations to on hinge. This dispenses with the need for adjustment after installation.
If this is not possible, adjust ENGINE HOOD .