27 10 020 Installing Distributor Exchange Transmission (ATC 450)
WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Before and after replacement, execute the "Repair" service function with the BMW diagnosis system.
Recycling:
Catch and dispose of escaping transmission oil. Observe country-specific waste disposal regulations.
Necessary preliminary tasks:
- Drain TRANSMISSION OIL at oil drain plug.
Tightening torque: 27 00 11AZ .
- Remove TRANSFER BOX .
Modify following parts:
- Covers and protective caps.
- Drive shaft transportation retainer.
- Vent hose of transfer box.
- If required, replace RUBBER MOUNT for transmission mounting.
IMPORTANT:
After completing work, check transmission oil level and top up if necessary.
Release filler plug (1).
Check oil level.
Tightening torque: 27 00 11AZ .
Pour in transmission oil up to lower edge of opening for filler plug (1).
Use only the approved transmission oil .
Release filler plug (1).
Check oil level.
Tightening torque: 27 00 11AZ .
Pour in transmission oil up to lower edge of opening for filler plug (1).
Use only the approved transmission oil .
Failure to comply with this requirement will result in serious damage to the transfer box!