52 26 200 Removing and installing/replacing rear panel on right rear seat back (through-loading)

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove REAR SEAT BACK

Unclip lock trim on backrest edge in direction of arrow (1).

Slide back of lock trim in outward direction and remove in direction of arrow (2).

Fig 1: Removing Seat Backrest Lock Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retaining lugs on trim must not be damaged.

Fig 2: Locating Seat Backrest Retaining Lugs

Courtesy of BMW OF NORTH AMERICA, INC.

Lever backrest cover all round out of backrest frame.

Fig 3: Removing Backrest Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Detach rear panel (2) with flat scraper (1) from rear seat back.

Installation:

Comply with instructions issued by manufacturer of universal spray adhesive.

Apply universal spray adhesive to rear panel and rear seat back.

Fit and align rear panel within the air drying time (see manufacturer's instructions).

Observe and adhere to curing time to prevent rear panels from slipping.

Fig 4: Detaching Rear Panel Using Flat Scraper From Rear Seat Back

Courtesy of BMW OF NORTH AMERICA, INC.